Getting back onto the Rover P6 this month . . .
Work resumes on Gary's Rover P6 project this month. The old back axle has been removed for a freshen up before going into the repaired shell. Once the shell is rolling again we can sort out...
New Timber for the Morris Traveller
The new timber has finally arrived for the restoration on the Morris Traveller. Initial fit and fettle so we can get the inner rear wings welded into the correct position. Then all off and prep and...
Low oil pressure on Triumph TR6
This lovely Triumph TR6 came into the workshop suffering from low oil pressure when hot. A previous garage fitted a new pump and bizarrely 3 main shells in an attempt to fix the issue. Clearly misguided!...
Extensive metalwork needed on Jack’s T25
This T25 came in for a bit of bodywork TLC . . . We ended up replacing the outer sill, B post, front arch and step, repairing the seat base and battery box and the rear...
VW T2 Late Bay Window camper restoration continues . . .
The restoration of the very rusty T2 camper still continues. The N/S chassis outriggers, inner and outer sills and front and rear arches have now been replaced with new panels. Onto the O/S now . ....
Running issues sorted on an MGB this week . . .
We were tasked with getting this lovely MGB Roadster running properly this week. A good check over revealed hardly any air was getting into the rear carburettor. She left the workshop purring away after setting up...
Rebuilt 2.1 engine conversion for a T25
Jim wanted us to treat his VW T25 camper to a new engine. So out with the tired 1.9DG waterboxer and in with a freshly built 2.1DJ
I don’t think that hole should be there . . .
Matt's T2 camper came in this week for a replacement engine - he certainly made a good job of destroying the old unit!
P6 metalwork progress . . .
All in all the base unit on Gary's P6 isnt that bad. The worst area being under the rear deck panel. Lots of leaves trapped and holding moisture. One side complete now onto the other ....
Metalwork repairs on Gary’s P6
We finally got the Rover P6 base unit into the workshop to start on the metalwork repairs. This will form the start of Gary's project - 'Bruiser' 2! Based around an engine I supplied to him...
01635 783385